[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[plamo:07988] Re: Dynabook DB55C
-
From:Chie Nakatani
-
Date:Fri, 15 Dec 2000 17:19:47 +0900
- Subject: [plamo:07988] Re: Dynabook DB55C
- From: Chie Nakatani <jeanne@xxxxxxxxxxxxxxxxxxxxx>
- Date: Fri, 15 Dec 2000 17:19:47 +0900
- Posted: Fri, 15 Dec 2000 17:19:16 +0900
たむき さん、こんにちは
> > すみません,参考までに教えてください。これって,カーネルのtulip.cを置
> > き換えているのですが,例えば最新のpcmcia-csドライバを使えば動くという可
> > 能性はあるでしょうか?
>
> pcmcia-csは、全く関係ありません。無くても、動きます(^^;
はい、おきかえて、make menucofig で tulip をチェックしてから
makedep;make clean;make してます。モジュールにしても大丈夫だと思いますが、
とりあえずチェックして組み込んでみました。
それから、
pcmcia の起動は rc.S のほうで、こういう部分がありますので、
# Initialize PCMCIA devices:
#
# NOTE: This had been closer to the top of this script so that PCMCIA devices
# could be fsck'ed along with the other drives. This had some unfortunate
# side effects, however, since root isn't yet read-write, and /var might not
# even be mounted the .pid files can't be correctly written in /var/run and
# the pcmcia system can't be correctly shut down. If you want some PCMCIA
# partition to be mounted at boot (or when the card is inserted) then add
# the appropriate lines to /etc/pcmcia/scsi.opts.
#
if [ -x /etc/rc.d/rc.pcmcia ] ; then
. /etc/rc.d/rc.pcmcia start
fi
コメントをつけて start しないように止めています。
中谷千絵
- References
-
- [plamo:07987] Re: Dynabook DB55C, Kazumasa kawai (川井和正)
[検索ページ]
[メール一覧]
Plamo ML 公開システム