[plamo:28144] Re: libata installer

[名倉昭一]

  名倉 です。

> 冨岡です＠ 名倉さんの i430TX で期待したのですが！
> 
> ASUS P/I-P55T2P4(Rev 2.3) での結果です。
> 
  えっ.....???ということで　i430VXのshuttle HOT-557(ver1.5)　BIOS 55xWSQ0F
  やってみました。
　ちなみにASUS TXP4のBIOSは最終beta版です。

　ううーんだめでした。

　　i430TX  からサポートされたのは UDMA33 ACPI のはず?

  以下長くてすいませんが参考まで lspci とdmesgの抜粋です。

　00:00.0 Class 0600: 8086:7030 (rev 02)
        Flags: bus master, medium devsel, latency 64

　00:07.0 Class 0601: 8086:7000 (rev 01)
        Flags: bus master, medium devsel, latency 0

　00:07.1 Class 0101: 8086:7010 (prog-if 80 [Master])
        Flags: bus master, medium devsel, latency 64
        [virtual] Memory at 000001f0 (32-bit, non-prefetchable) [disabled] [size=8]
        [virtual] Memory at 000003f0 (type 3, non-prefetchable) [disabled]
        [virtual] Memory at 00000170 (32-bit, non-prefetchable) [disabled] [size=8]
        [virtual] Memory at 00000370 (type 3, non-prefetchable) [disabled]
        I/O ports at f000 [size=16]

　00:07.2 Class 0c03: 8086:7020 (rev 01)
        Flags: bus master, medium devsel, latency 64, IRQ 11
        I/O ports at 6000 [size=32]

　00:12.0 Class 0300: 1039:6326 (rev 0b)
        Subsystem: 1569:6326
        Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 10
        Memory at e0000000 (32-bit, prefetchable) [size=8M]
        Memory at e0900000 (32-bit, non-prefetchable) [size=64K]
        I/O ports at 6400 [size=128]
        Expansion ROM at 10100000 [disabled] [size=64K]
        Capabilities: [40] Power Management version 1

　00:13.0 Class 0200: 8086:1229 (rev 02)
        Subsystem: 8086:0001
        Flags: bus master, medium devsel, latency 64, IRQ 11
        Memory at e0910000 (32-bit, prefetchable) [size=4K]
        I/O ports at 6800 [size=32]
        Memory at e0800000 (32-bit, non-prefetchable) [size=1M]
        Expansion ROM at 10000000 [disabled] [size=1M]

　00:14.0 Class 0100: 9004:8078
        Flags: bus master, medium devsel, latency 64, IRQ 9
        I/O ports at 6c00 [disabled] [size=256]
        Memory at e0911000 (32-bit, non-prefetchable) [size=4K]
        Expansion ROM at 10110000 [disabled] [size=64K]

　S-e820: 0000000000100000 - 0000000006000000 (usable)
 　BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
　0MB HIGHMEM available.
　96MB LOWMEM available.
　Entering add_active_range(0, 0, 24576) 0 entries of 256 used
　Zone PFN ranges:
  　DMA             0 ->     4096
  　Normal       4096 ->    24576
  　HighMem     24576 ->    24576
　early_node_map[1] active PFN ranges
    0:        0 ->    24576
　On node 0 totalpages: 24576
  　DMA zone: 32 pages used for memmap
  　DMA zone: 0 pages reserved
  　DMA zone: 4064 pages, LIFO batch:0
  　Normal zone: 160 pages used for memmap
  　Normal zone: 20320 pages, LIFO batch:3
  　HighMem zone: 0 pages used for memmap
　DMI 2.0 present.
　ACPI: Unable to locate RSDP
　Allocating PCI resources starting at 10000000 (gap: 06000000:f9ff0000)
　Detected 199.912 MHz processor.
　Built 1 zonelists.  Total pages: 24384
　Kernel command line: initrd=initrd.gz BOOT_IMAGE=vmlinuz
　No local APIC present or hardware disabled
　mapped APIC to ffffd000 (010c1000)
　Initializing CPU#0
　PID hash table entries: 512 (order: 9, 2048 bytes)
　Console: colour VGA+ 80x25
　Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
　Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
　Memory: 79116k/98304k available (2637k kernel code, 18740k reserved, 899k data, 244k init, 0k highmem)
　virtual kernel memory layout:
    fixmap  : 0xfffa9000 - 0xfffff000   ( 344 kB)
    pkmap   : 0xff800000 - 0xffc00000   (4096 kB)
    vmalloc : 0xc6800000 - 0xff7fe000   ( 911 MB)
    lowmem  : 0xc0000000 - 0xc6000000   (  96 MB)
      .init : 0xc0478000 - 0xc04b5000   ( 244 kB)
      .data : 0xc039360f - 0xc04743f4   ( 899 kB)
      .text : 0xc0100000 - 0xc039360f   (2637 kB)
　Checking if this processor honours the WP bit even in supervisor mode... Ok.
　Calibrating delay using timer specific routine.. 400.15 BogoMIPS (lpj=200075)
　Mount-cache hash table entries: 512
　CPU: After generic identify, caps: 008001bf 008005bf 00000000 00000000 00000000 00000000 00000000
　CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
　CPU: After all inits, caps: 008001bf 008005bf 00000000 00000000 00000000 00000000 00000000
　Compat vDSO mapped to ffffe000.
　CPU: AMD-K6tm w/ multimedia extensions stepping 02
　Checking 'hlt' instruction... OK.
　NET: Registered protocol family 16
　PCI: PCI BIOS revision 2.10 entry at 0xfb000, last bus=0
　PCI: Using configuration type 1
　Setting up standard PCI resources
　ACPI: Interpreter disabled.
　Linux Plug and Play Support v0.97 (c) Adam Belay
　pnp: PnP ACPI: disabled
　SCSI subsystem initialized
　libata version 2.00 loaded.
　PCI: Probing PCI hardware
　PCI: Probing PCI hardware (bus 00)
　Boot video device is 0000:00:12.0
　PCI: Firmware left 0000:00:13.0 e100 interrupts enabled, disabling
　PCI: Using IRQ router PIIX/ICH [8086/7000] at 0000:00:07.0
　NET: Registered protocol family 2
　IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
　TCP established hash table entries: 4096 (order: 2, 16384 bytes)
　TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
　TCP: Hash tables configured (established 4096 bind 2048)
　TCP reno registered
　checking if image is initramfs... it is
　Freeing initrd memory: 13757k freed
　audit: initializing netlink socket (disabled)
　audit(1179777935.173:1): initialized
　Total HugeTLB memory allocated, 0
　VFS: Disk quotas dquot_6.5.1
　Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
　io scheduler noop registered
　io scheduler cfq registered (default)
　Limiting direct PCI/PCI transfers.
　Activating ISA DMA hang workarounds.
　vga16fb: initializing
　vga16fb: mapped to 0xc00a0000
　Console: switching to colour frame buffer device 80x30
　fb0: VGA16 VGA frame buffer device
　Real Time Clock Driver v1.12ac
　RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
　input: Macintosh mouse button emulation as /class/input/input0
　PCI: setting IRQ 9 as level-triggered
　PCI: Found IRQ 9 for device 0000:00:14.0
　scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 7.0
        <Adaptec aic7880 Ultra SCSI adapter>
        aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs

　scsi 0:0:0:0: Direct-Access     ALPS     DR322D491A        1.0 PQ: 0 ANSI: 2
　scsi0:A:0:0: Tagged Queuing enabled.  Depth 32
 　target0:0:0: Beginning Domain Validation
 　target0:0:0: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 15)
 　target0:0:0: Domain Validation skipping write tests
 　target0:0:0: Ending Domain Validation
　scsi 0:0:1:0: Direct-Access     ALPS     DR322D491A        1.0 PQ: 0 ANSI: 2
　scsi0:A:1:0: Tagged Queuing enabled.  Depth 32
 　target0:0:1: Beginning Domain Validation
 　target0:0:1: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 15)
 　target0:0:1: Domain Validation skipping write tests
 　target0:0:1: Ending Domain Validation
　megaraid cmm: 2.20.2.7 (Release Date: Sun Jul 16 00:01:03 EST 2006)
　megaraid: 2.20.4.9 (Release Date: Sun Jul 16 12:27:22 EST 2006)
　SCSI device sda: 1065390 512-byte hdwr sectors (545 MB)
　sda: Write Protect is off
　sda: Mode Sense: 79 00 00 08
　SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
　SCSI device sda: 1065390 512-byte hdwr sectors (545 MB)
　sda: Write Protect is off
　sda: Mode Sense: 79 00 00 08
　SCSI device sda: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
　　 sda: sda1 sda2
　sd 0:0:0:0: Attached scsi disk sda
　SCSI device sdb: 1065390 512-byte hdwr sectors (545 MB)
　sdb: Write Protect is off
　sdb: Mode Sense: 79 00 00 08
　SCSI device sdb: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
　SCSI device sdb: 1065390 512-byte hdwr sectors (545 MB)
　sdb: Write Protect is off
　sdb: Mode Sense: 79 00 00 08
　SCSI device sdb: write cache: enabled, read cache: enabled, doesn't support DPO or FUA
 　sdb: sdb1
　sd 0:0:1:0: Attached scsi disk sdb
　Fusion MPT base driver 3.04.03
　Copyright (c) 1999-2007 LSI Logic Corporation
　Fusion MPT SPI Host driver 3.04.03
　Fusion MPT FC Host driver 3.04.03

　　以下略