[plamo:25069] Re: 無線LAN接続方法(AR5212チップ)

[小見山拓也]

On Thu, 10 Mar 2005 23:42:49 +0900 (JST)
Shun-ichi TAHARA <jado@flowernet.gr.jp> (田原 俊一) wrote:

小見山です。

> > *,*,00:0f:b5:*|*,*,0d:7b:4e:*)
> 
> ここのMACアドレスは大文字で書いてください。
はい、大文字で書き直しました。書き方は

*,*,00:0F:B5:*|*,*,0D:7B:4E:*)

でよかったでしょうか？

その後 Super A/G をルータ側で OFF にしてLinuxを起動しましたが、やはり動
きませんでした。iwconfig で見る限りでは

ath0      IEEE 802.11a  ESSID:"xxxxxxxx" NickName="xxxxxxxx" 
          Mode:Managed  Frequency:2.412GHz  Access Point:FF:FF:FF:FF:FF:FF
          Bit Rate:0kb/s   Tx-Power:50 dBm   Sensitivity=0/3  
          Retry:off   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality:0/94  Signal level:-95 dBm  Noise level:-95 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

となっています。lsmod では

Module                  Size  Used by    Tainted: P  
nls_cp437               4348   1  (autoclean)
vfat                   10540   1  (autoclean)
fat                    31960   0  (autoclean) [vfat]
usb-storage           119216   1 
nfsd                   72816   1  (autoclean)
lockd                  49616   1  (autoclean) [nfsd]
sunrpc                 68544   1  (autoclean) [nfsd lockd]
ath_pci                39856   0 
wlan_wep                3744   0  (unused)
ath_rate_onoe           3976   0  [ath_pci]
wlan                   84824   1  [ath_pci wlan_wep ath_rate_onoe]
ath_hal               133936   1  [ath_pci]
ds                      7060   2 
yenta_socket           10788   2 
pcmcia_core            46368   0  [ds yenta_socket]
usb-uhci               23344   0  (unused)
usbcore                62988   1  [usb-storage usb-uhci]
nls_cp932              76512   1  (autoclean)
nls_euc-jp              4116   2  (autoclean)
ntfs                   54400   1  (autoclean)

dmesg コマンドでみると

Linux Kernel Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Intel ISA PCIC probe: not found.
PCI: Enabling device 02:0f.0 (0000 -> 0002)
PCI: Enabling device 02:0f.1 (0000 -> 0002)
Yenta ISA IRQ mask 0x00d8, PCI irq 10
Socket status: 30000020
Yenta ISA IRQ mask 0x00d8, PCI irq 10
Socket status: 30000006
cs: cb_alloc(bus 4): vendor 0x168c, device 0x0013
PCI: Enabling device 04:00.0 (0000 -> 0002)
ath_hal: 0.9.14.9 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413)
wlan: 0.8.4.5 (EXPERIMENTAL)
ath_rate_onoe: 1.0
ath_pci: 0.9.4.12 (EXPERIMENTAL)
ath0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
ath0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ath0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
ath0: turbo rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
ath0: mac 5.9 phy 4.3 radio 3.6
ath0: 802.11 address: 00:0f:b5:0d:7b:4e
ath0: Use hw queue 0 for WME_AC_BE traffic
ath0: Use hw queue 1 for WME_AC_BK traffic
ath0: Use hw queue 2 for WME_AC_VI traffic
ath0: Use hw queue 3 for WME_AC_VO traffic
ath0: Atheros 5212: mem=0x10800000, irq=10
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x280-0x287 0x370-0x37f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
ath0 (WE) : Buffer for request SIOCGIWPRIV too small (16<59)
ath0 (WE) : Buffer for request SIOCGIWPRIV too small (32<59)
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).

となっていて、

ath0 (WE) : Buffer for request SIOCGIWPRIV too small (16<59)
ath0 (WE) : Buffer for request SIOCGIWPRIV too small (32<59)

の2行があやしいのではないかと思っています。

-- 
Takuya Komiyama <tora@aqua.email.ne.jp>