[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[plamo:26540] cdrom(hdc)デバイスが認識できない
-
From:Tetsuya Yamashita
-
Date:Mon, 24 Oct 2005 00:01:01 +0900 (JST)
- Subject: [plamo:26540] cdrom(hdc)デバイスが認識できない
- From: Tetsuya Yamashita <yamashit@xxxxxxxxxxxxxxxxx>
- Date: Mon, 24 Oct 2005 00:00:59 +0900
御世話になっています。やました といいます。
Plamo4.03をNECのPC-LL9007DにCD(ダウンロードしたisoイメージを焼いたもの)から
インストールしました。インストール時にはhdcとして認識したCDドライブが、
インストール後、認識しない状態になっています。(ドライブは MATSHITA DVD-RAM UJ-811 )
dmesgをみてもドライブが認識されている様子がありません。
起動時のパラメータにhdc=cdromを追加すると、下記のようなログがでます。
インストール時に認識されているのでなんとか動かしたいのですが、何をどうすれば
いいのか、何を確認すれば全くわからない状態です。
何らかのアドバイスをいただきたいのですが、何卒よろしくお願いします。
---dmesgのログ(抜粋)---
hdc: no response (status = 0xff), resetting drive
hdc: no response (status = 0xff)
hdc: ATAPI cdrom (?)
ide1 at 0x170-0x177,0x376 on irq 15
Probing IDE interface ide2...
Probing IDE interface ide3...
Probing IDE interface ide4...
Probing IDE interface ide5...
hda: max request size: 1024KiB
hda: 156301488 sectors (80026 MB) w/7877KiB Cache, CHS=16383/255/63, UDMA(100)
hda: cache flushes supported
hda: hda1 hda2 hda3 hda4
hdc: status timeout: status=0xff { Busy }
ide: failed opcode was: unknown
hdc: drive not ready for command
hdc: ATAPI reset timed-out, status=0xff
ide1: reset timed-out, status=0xff
hdc: status timeout: status=0xff { Busy }
ide: failed opcode was: unknown
hdc: drive not ready for command
hdc: ATAPI reset timed-out, status=0xff
ide1: reset timed-out, status=0xff
hdc: ATAPI CD-ROM drive, 0kB Cache
Uniform CD-ROM driver Revision: 3.20
-----ここまで----
[検索ページ]
[メール一覧]
Plamo ML 公開システム