[plamo:28157] Re: libata installer (i586i430VX起動)

[Mikio Tomioka]

冨岡＠追加報告です。

> ASUS P/I-P55T2P4(Rev 2.3) (i430HX)  とりあえず認識でき、ルートファイル
> システム、swap をマウントできたようです。 現時点 HDD が不調で

名倉さんと同じ方法（別マシンでインストールした HDD を接続）で動作し
ました。やはり HDD が不良でした。

FMV-475NL/T (i486DX4(75MHz), mem = 8M + 16Mbyte)
でも 1FD の起動テストしてみました。
（ .config を少し変更しシリアルへ起動メッセージを出力させる）

以下メッセージの抜粋です。

・ ASUS P/I-P55T2P4(Rev 2.3) (i430HX)

# dmesg
[    0.000000] Linux version 2.6.22-rc3-libata2fd (root@vm-plamo421) (gcc version 4.1.2) #2 PREEMPT Mon May 28 11:56:57 JST 2007

 === 略 ===

[   64.565375] ata_piix 0000:00:07.1: version 2.11
[   64.566267] PCI: Setting latency timer of device 0000:00:07.1 to 64
[   64.567512] scsi0 : ata_piix
[   64.569202] scsi1 : ata_piix
[   64.570510] ata1: PATA max MWDMA2 cmd 0x000101f0 ctl 0x000103f6 bmdma 0x0001e800 irq 14
[   64.570712] ata2: PATA max MWDMA2 cmd 0x00010170 ctl 0x00010376 bmdma 0x0001e808 irq 15
[   64.803426] ata1.00: ATA-3: FUJITSU MHD2021AT, 1018, max UDMA/33
[   64.803587] ata1.00: 4233600 sectors, multi 0: LBA 
[   64.866393] ata1.00: configured for MWDMA2
[   65.187335] ata2.00: ATAPI, max PIO3
[   65.361262] ata2.00: configured for PIO3
[   65.362924] scsi 0:0:0:0: Direct-Access     ATA      FUJITSU MHD2021A 1018 PQ: 0 ANSI: 5
[   65.365724] sd 0:0:0:0: [sda] 4233600 512-byte hardware sectors (2168 MB)
[   65.366233] sd 0:0:0:0: [sda] Write Protect is off
[   65.366376] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
[   65.366760] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[   65.367895] sd 0:0:0:0: [sda] 4233600 512-byte hardware sectors (2168 MB)
[   65.368375] sd 0:0:0:0: [sda] Write Protect is off
[   65.368510] sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
[   65.368896] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[   65.369209]  sda: sda1 sda2
[   65.497619] sd 0:0:0:0: [sda] Attached SCSI disk
[   65.508649] scsi 1:0:0:0: CD-ROM            TEAC     PD-1 CD-P520E    2.0L PQ: 0 ANSI: 5
[   65.557450] sr0: scsi3-mmc drive: 20x/20x writer cd/rw xa/form2 cdda tray
[   65.557628] Uniform CD-ROM driver Revision: 3.20
[   65.559063] sr 1:0:0:0: Attached scsi CD-ROM sr0

=============================

・ FMV-475NL/T (i486DX4(75MHz), mem = 8M + 16Mbyte) の起動メッセージ

SYSLINUX 3.36 2007-02-10  Copyright (C) 1994-2007 H. Peter Anvin
Loading linux.........................Ready.
Linux version 2.6.22-rc3-libata2fd (root@vm-plamo421) (gcc version 4.1.2) #4 PREEMPT Tue May 29 13:06:04 JST 2007

 === 略 ===

serial8250.0: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
scsi0 : pata_legacy
ata1: PATA max PIO4 cmd 0x000101f0 ctl 0x000103f6 bmdma 0x00000000 irq 0
ata1.00: ATA-0: TOSHIBA MK1923FCV, S0.11 A, max MWDMA2
ata1.00: 796284 sectors, multi 0: LBA 
ata1.00: configured for PIO
scsi 0:0:0:0: Direct-Access     ATA      TOSHIBA MK1923FC S0.1 PQ: 0 ANSI: 5
sd 0:0:0:0: [sda] 796284 512-byte hardware sectors (408 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
sd 0:0:0:0: [sda] 796284 512-byte hardware sectors (408 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
 sda: sda1 sda2 sda3
sd 0:0:0:0: [sda] Attached SCSI disk


# EP-ROM writer, RS-232C ラインモニターの専用マシン(DOS)になっています。
# 1FD で少し遊べそうです。ありがとう御座います。


---------
とみおか