[plamo:28257] Re: 再度libataテストしてみました。(追記)

[名倉昭一]

   名倉@Turion64なAopen EX761までPlamo-4.22β1(2007/07/04 22:32)にしてしまった です。
 
> 　linux-2.6.22-rc7-git2でlibataかなり手が入ったようです。
> 　再度テストをと思っていましたが。
> 
> 　http://www.ussg.iu.edu/hypermail/linux/kernel/0707.0/0684.html
> 　このあたりでもテストを呼びかけているようです。
> 
> 　とりあえず下記3点やって見ました。
> 
>   いままで起動しなかったPVI486-SP3が起動するようになりました。
> 
> 　1. Asus TXP4(intel 430TX)
  (省略)
>      [    5.249000] pnp: the driver 'pata_isapnp' has been registered

    X11R7.2に遊んでもらう用のPlamo-4.22β1を入れてあった
　　AMD Athlon(tm) 64 X2 Dual Core Processor 3800+なマシンもlibataベースにしました。

    4. Shuttle SS21T(SIS 761GX + SIS966L)

      [    0.386000] megaraid: 2.20.5.1 (Release Date: Thu Nov 16 15:32:35 EST 2006)
      [    0.387000] ahci 0000:00:05.0: version 2.2
      [    0.387000] ACPI: PCI Interrupt 0000:00:05.0[A] -> GSI 17 (level, low) -> IRQ 17
      [    1.891000] ahci 0000:00:05.0: failed to stop engine (-5)
      [    1.892000] ahci 0000:00:05.0: AHCI 0001.0000 32 slots 2 ports 1.5 Gbps 0x3 impl RAID mode
      [    1.893000] ahci 0000:00:05.0: flags: ncq led clo pio
      [    1.894000] PCI: Setting latency timer of device 0000:00:05.0 to 64
      [    1.894000] scsi0 : ahci
      [    1.895000] PM: Adding info for No Bus:host0
      [    1.895000] scsi1 : ahci
      [    1.896000] PM: Adding info for No Bus:host1
      [    1.896000] ata1: SATA max UDMA/133 cmd 0xf8830100 ctl 0x00000000 bmdma 0x00000000 irq 17
      [    1.897000] ata2: SATA max UDMA/133 cmd 0xf8830180 ctl 0x00000000 bmdma 0x00000000 irq 17
      [    2.201000] ata1: SATA link down (SStatus 0 SControl 300)
      [    2.505000] ata2: SATA link down (SStatus FFFFFFFF SControl FFFFFFFF)
      [    2.506000] pata_sis 0000:00:02.5: version 0.5.1
      [    2.506000] ACPI: PCI Interrupt 0000:00:02.5[A] -> GSI 16 (level, low) -> IRQ 16
      [    2.508000] scsi2 : pata_sis
      [    2.509000] PM: Adding info for No Bus:host2
      [    2.509000] scsi3 : pata_sis
      [    2.510000] PM: Adding info for No Bus:host3
      [    2.510000] ata3: PATA max UDMA/133 cmd 0x000101f0 ctl 0x000103f6 bmdma 0x00014000 irq 14
      [    2.511000] ata4: PATA max UDMA/133 cmd 0x00010170 ctl 0x00010376 bmdma 0x00014008 irq 15
      [    2.820000] ata3.00: ATA-4: QUANTUM FIREBALLlct08 13, A05.0X00, max UDMA/66
      [    2.821000] ata3.00: 25429824 sectors, multi 16: LBA
      [    2.822000] ata3.01: ATAPI: MATSHITADVD-ROM SR-8587, 5Z37, max UDMA/33
      [    2.823000] ata3.00: limited to UDMA/33 due to 40-wire cable
      [    2.830000] ata3.00: configured for UDMA/33
      [    2.988000] ata3.01: configured for UDMA/33
      [    2.989000] ata4: port disabled. ignoring.
      [    2.989000] PM: Adding info for No Bus:target2:0:0
      [    2.989000] scsi 2:0:0:0: Direct-Access     ATA      QUANTUM FIREBALL A05. PQ: 0 ANSI: 5
      [    2.990000] PM: Adding info for scsi:2:0:0:0
      [    2.990000] sd 2:0:0:0: [sda] 25429824 512-byte hardware sectors (13020 MB)
      [    2.991000] sd 2:0:0:0: [sda] Write Protect is off
      [    2.992000] sd 2:0:0:0: [sda] Mode Sense: 00 3a 00 00
      [    2.992000] sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
      [    2.993000] sd 2:0:0:0: [sda] 25429824 512-byte hardware sectors (13020 MB)
      [    2.994000] sd 2:0:0:0: [sda] Write Protect is off
      [    2.995000] sd 2:0:0:0: [sda] Mode Sense: 00 3a 00 00
      [    2.995000] sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
      [    2.996000]  sda: sda1 sda2
      [    3.008000] sd 2:0:0:0: [sda] Attached SCSI disk
      [    3.009000] PM: Adding info for No Bus:target2:0:1
      [    3.009000] scsi 2:0:1:0: CD-ROM            MATSHITA DVD-ROM SR-8587  5Z37 PQ: 0 ANSI: 5
      [    3.010000] PM: Adding info for scsi:2:0:1:0
      [    3.012000] sr0: scsi3-mmc drive: 48x/48x cd/rw xa/form2 cdda tray
      [    3.013000] Uniform CD-ROM driver Revision: 3.20
      [    3.014000] sr 2:0:1:0: Attached scsi CD-ROM sr0
      [    3.014000] Fusion MPT base driver 3.04.04