[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[plamo:02986] I can't reach external servers.
-
From:Naoki Sugita
-
Date:Mon, 14 Jun 1999 19:19:50 +0900
- Subject: [plamo:02986] I can't reach external servers.
- From: Naoki Sugita <a5e050@xxxxxxxxxxxxxxxxxxxx>
- Date: Mon, 14 Jun 1999 19:19:50 +0900
- Posted: Mon, 14 Jun 1999 19:19:18 +0900
初めて 投稿いたします
________________________________________________________________________________________
>> PPxPを使ったPPP接続による通信ができず困っています。 <<
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
自分の環境は
・カーネル2.0.36
・Plamo Linux 1.4.1
・デスクトップ環境で、com1にTAを接続。com2は[disable]
基本的にPPP接続事態はできているようです。IPアドレスの取得もできていま
す。
しかし、接続完了、pingしても応答が帰ってきません。
自分なりに考えてみましたが、どこが悪いのか分かりません。
以下に、ppxpでつないだときのifconfig及び、netstatの応答を示します。
また、起動時の問題を見落としているかもしれないので、dmesgの応答も示しま
す。
あと、どのような情報を送れば良いのか分からないので情報不足であれば、ご指
摘いただくとうれしいです。
どなたか おちからをお貸しください
=========================================================================
・デフォルトの設定ではネットワークインターフェースであるeth0が確認できま
せんでした。
ネットワークカードはささっているのですが「ケーブルはつなげていないの
で必要ない」と思い、
/etc/rc.d/rc.inet1のethernetに関係する箇所をコメントアウトしていま
す。
.・qdialしたときの状態を示します。
#ifconfig -a
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:20 errors:0 dropped:0 overruns:0 frame:0
TX packets:20 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
ul0 Link encap:Point-to-Point Protocol
inet addr:133.8.38.47 P-t-P:133.8.38.32 Mask:255.255.0.0
UP POINTOPOINT RUNNING MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
#netstat -rn
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window
irtt Iface
133.8.38.32 0.0.0.0 255.255.255.255 UH 1500 0
0 ul0
127.0.0.0 0.0.0.0 255.0.0.0 U 3584 0
0 lo
0.0.0.0 133.8.38.32 0.0.0.0 UG 1500 0
0 ul0
・ブート時の状態です
#dmesg
Memory: sized by int13 088h
Console: 16 point font, 400 scans
Console: colour VGA+ 80x25, 1 virtual console (max 63)
pcibios_init : BIOS32 Service Directory structure at
0x000f0280
pcibios_init : BIOS32 Service Directory entry at 0xf0210
pcibios_init : PCI BIOS revision 2.10 entry at 0xf0200
Probing PCI hardware.
Calibrating delay loop.. ok - 52.84 BogoMIPS
Memory: 38944k/40960k available (712k kernel code, 384k
reserved, 920k data)
Swansea University Computer Society NET3.035 for Linux 2.0
NET3: Unix domain sockets 0.13 for Linux NET3.035.
Swansea University Computer Society TCP/IP for NET3.034
IP Protocols: IGMP, ICMP, UDP, TCP
Linux IP multicast router 0.07.
Checking 386/387 coupling... Ok, fpu using exception 16 error
reporting.
Checking 'hlt' instruction... Ok.
Intel Pentium with F0 0F bug - workaround enabled.
alias mapping IDT readonly ... ... done
Linux version 2.0.36 (root@boson) (gcc version 2.7.2.3) #2 Sun
Jun 6 17:17:38 JST 1999
Starting kswapd v 1.4.2.2
Serial driver version 4.13 with no serial options enabled
tty00 at 0x03f8 (irq = 4) is a 16550A
PS/2 auxiliary pointing device detected -- driver installed.
Ramdisk driver initialized : 16 ramdisks of 4096K size
loop: registered device at major 7
hda: WDC AC2420F, 405MB w/64kB Cache, CHS=989/15/56
hdb: QUANTUM FIREBALL EL2.5A, 2445MB w/418kB Cache,
CHS=621/128/63
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
scsi : 1 host.
scsi : detected total.
Partition check:
hda: hda1
hdb: hdb1 hdb2 hdb3
VFS: Mounted root (ext2 filesystem) readonly.
Unable to load NLS charset cp437(nls_cp437)
Unable to load NLS charset cp437(nls_cp437)
Unable to load NLS charset iso8859-1(nls_iso8859_1)
userlink version 0.98a-2 registered major 127
- Follow-Ups
-
- [plamo:02987] Re: I can't reach external servers., Katsumi Hagio
[検索ページ]
[メール一覧]
Plamo ML 公開システム