[plamo:08664] Planex FNW-9702-T/T3 Ethernet Card

[Norio Saitoh]

初めまして。齋藤です。様々な問題をＭＬを読んで解決してきましたが、
今回ばかりはどうにもならないので、皆様に教えを請うことになりまし
た。

さて、私はPlamo 2.1を利用していますが、このたびPCIのFNW-9702とい
うLinux Readyと書いてあったNICを購入しました。このNICはVIA 
VT6102というチップを載せており、Plamo2.1のVia Rhineでカーネルを
作成しても認識不可でした。製品にはそのLinux用のドライバは付いて
いたのですがコンパイルがうまくできませんでした。linux-userをはじ
めとする各ＭＬで調べたところ、かなりトリッキーなことをして動かし
ているので、いっそのこと最新カーネル2.4.1で認識させることにしま
した。
2.4.1のdriver/net/via-rhine.cに VT6102　の項があったので、大丈夫
とにらみ、インストール・カーネルの作成を行いました。結果、認識が
できたようですが、下のようにNICアドレスが帰ってこない状態で、ネ
ットワークに対しpingを飛ばすことすらできない状態です。（念のため、
最新のmodutil-2.4.2も入れました。）どこに原因があるのでしょうか。
よろしくお願いいたします。

------ifconfig--
eth0      Link encap:Ethernet  HWaddr 00:00:00:00:00:00  
          inet addr:192.168.0.5  Bcast:192.168.0.255  Mask:255.
255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:10 Base address:0xa800 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16192  Metric:1
          RX packets:18 errors:0 dropped:0 overruns:0 frame:0
          TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 

------cat /proc/pci | grep -A 3 Ethernet--
Ethernet controller: VIA Technologies, Inc. Ethernet Controller 
(rev 66).
      IRQ 10.
      Master Capable.  Latency=32.  Min Gnt=3.Max Lat=8.
      I/O at 0xa800 [0xa8ff].

------dmesg--
Linux version 2.4.1 (XXXXX) (gcc version 2.95.2 19991024 
(release)) #3 SMP 2001ヌッ 2キ・1ニ・(ニ・ 23:30:22 JST
BIOS-provided physical RAM map:
 BIOS-e820: 000000000009f400 @ 0000000000000000 (usable)
 BIOS-e820: 0000000000000c00 @ 000000000009f400 (reserved)
 BIOS-e820: 0000000000010000 @ 00000000000f0000 (reserved)
 BIOS-e820: 000000000fefc000 @ 0000000000100000 (usable)
 BIOS-e820: 0000000000003000 @ 000000000fffc000 (ACPI data)
 BIOS-e820: 0000000000001000 @ 000000000ffff000 (ACPI NVS)
 BIOS-e820: 0000000000010000 @ 00000000ffff0000 (reserved)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Scan SMP from c009fc00 for 4096 bytes.
On node 0 totalpages: 65532
zone(0): 4096 pages.
zone(1): 61436 pages.
zone(2): 0 pages.
mapped APIC to ffffe000 (01444000)
Kernel command line: 
Initializing CPU#0
Detected 701.606 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1399.19 BogoMIPS
Memory: 255024k/262128k available (1298k kernel code, 6716k 
reserved, 507k data, 220k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, 
vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 
00000000
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, 
vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 
00000000
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU0: Intel Pentium III (Coppermine) stepping 03
per-CPU timeslice cutoff: 731.88 usecs.
SMP motherboard not detected. Using dummy APIC emulation.
Setting commenced=1, go go go
PCI: PCI BIOS revision 2.10 entry at 0xf0890, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 1: assuming transparent
PCI: Using IRQ router VIA [1106/0686] at 00:04.0
isapnp: Scanning for Pnp cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
DMI 2.3 present.
44 structures occupying 1293 bytes.
DMI table at 0x000F1F30.
BIOS Vendor: Award Software, Inc.
BIOS Version: ASUS CUV4X ACPI BIOS Revision 1004
BIOS Release: 05/17/2000
System Vendor: System Manufacturer.
Product Name: System Name.
Version System Version.
Serial Number SYS-1234567890.
Board Vendor: ASUSTeK Computer INC..
Board Name: CUV4X.
Board Version: REV 1.xx.
Asset Tag: Asset-1234567890.
Starting kswapd v1.8
pty: 256 Unix98 ptys configured
Linux video capture interface: v1.00
V4L-Driver for Vision CPiA based cameras v0.7.4
block: queued sectors max/low 169432kB/56477kB, 512 slots per 
queue
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override 
with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 21
VP_IDE: chipset revision 16
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686a IDE UDMA66 controller on pci0:4.1
    ide0: BM-DMA at 0xd800-0xd807, BIOS settings: hda:DMA, hdb:
DMA
    ide1: BM-DMA at 0xd808-0xd80f, BIOS settings: hdc:DMA, hdd:
pio
hda: IBM-DTTA-350640, ATA DISK drive
hdb: IBM-DJNA-352030, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override 
with idebus=xx
hdc: RICOH DVD/CDRW MP9120, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 12692736 sectors (6499 MB) w/468KiB Cache, CHS=790/255/63
hdb: 39876480 sectors (20417 MB) w/1966KiB Cache, CHS=2482/255/
63
hdc: ATAPI 32X DVD-ROM CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda1
 hdb: hdb1 hdb2 hdb3 hdb4
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_
IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
via-rhine.c:v1.08b-LK1.1.6  8/9/2000  Written by Donald Becker
  http://www.scyld.com/network/via-rhine.html
PCI: Found IRQ 10 for device 00:0f.0
PCI: The same IRQ used for device 00:04.5
eth0: VIA VT6102 Rhine-II at 0xa800, 00:00:00:00:00:00, IRQ 10.
Mediavision Pro Movie Studio driver 0.02
PMS type is 0
Board not found.
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 203M
agpgart: Unsupported Via chipset (device id: 0605), you might 
want to try agp_try_unsupported=1.
agpgart: no supported devices found.
[drm] Initialized tdfx 1.0.0 20000928 on minor 63
[drm:radeon_init] *ERROR* Cannot initialize agpgart module.
[drm] The i810 drm module requires the agpgart module to 
function correctly
Please load the agpgart module before you load the i810 module
SCSI subsystem driver Revision: 1.00
sym53c8xx: at PCI bus 0, device 17, function 0
sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up)
sym53c8xx: 53c875 detected with Symbios NVRAM
sym53c875-0: rev 0x3 on pci bus 0 device 17 function 0 irq 11
sym53c875-0: Symbios format NVRAM, ID 0, Fast-20, Parity 
Checking
sym53c875-0: on-chip RAM at 0xdd800000
sym53c875-0: restart (scsi reset).
sym53c875-0: Downloading SCSI SCRIPTS.
scsi0 : sym53c8xx - version 1.6b
  Vendor: MATSHITA  Model: KME CD-ROM07      Rev: 1.12
  Type:   CD-ROM                             ANSI SCSI revision:
 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 1, lun 0
sym53c875-0-<1,*>: target did not report SYNC.
sym53c875-0-<1,*>: target did not report SYNC.
sr0: scsi-1 drive
Via 686a audio driver 1.1.14a
PCI: Found IRQ 10 for device 00:04.5
PCI: The same IRQ used for device 00:0f.0
ac97_codec: AC97 Audio codec, id: 0x4352:0x5934 (Cirrus Logic 
CS4299)
via82cxxx: board #1 at 0xB800, IRQ 10
es1371: version v0.27 time 23:32:15 Feb 11 2001
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 220k freed
Adding Swap: 289160k swap-space (priority -1)


--
Norio Saitoh
norio_s@yytv.ne.jp