[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[plamo:32794] Re: Plamo-7.1b1 テスター募集
-
From:Chie Nakatani
-
Date:Wed, 20 Mar 2019 20:19:37 +0900 (JST)
- Subject: [plamo:32794] Re: Plamo-7.1b1 テスター募集
- From: Chie Nakatani <jeannechie@xxxxxxxxxxxxxxxxxxxxx>
- Date: Wed, 20 Mar 2019 20:19:36 +0900
- Authentication-results: access01.SiriusCloud.jp; dkim=nonereason="no signature"; dkim-adsp=none (unprotected policy);dkim-atps=neutral
こんにちは
なんだか妙にわからないなぁという感じ
インストールそのものは別に問題なく
パーティションの大きさも60G〜300Gくらいまで3つほどの大きさを試し
ましたが、インストールそのものには別に問題ないのですが、
インストールを終了して、再起動すると、起動できない。
こんなメッセージを出して停止してしまいます。
USB ディスクは BUFFALO 500GB USB3.1
(手書きで写しているので間違いあるかも)
Loading Linux 4.19.29_plamo64...
Loading initial ramdisk...
mdadm:No araraays found in config file
or automatically
the device /dev/disk/by-uuid/ef83e8e7-adfe-4f15-81f4-f4b1c67cffd7
which is supposed to caontain the root file system,dose not exit.
Please fix this problem and exit this shelll
Encountered a problem!
Dropping you to a shell
sh:cannot set terminal prosess group(-1)
Inapproropriate ioctl for device
sh:no job control in this shell
sh: no job control in this shell
sh-4.4#
そこで、grub のメニュー画面がでたところで、
> set root=(hd0,msdos1)
>linux /boot/vmlinuz-4.19.29_plamo64 root=/dev/sdb1
>boot
これで起動させてみましたが、kernel panic で停止した
そういえば、
plamo6 の時はUSB ディスクに2個のパーティションを作っていて、
sdb2 を認識できないということで、インストールパーティションを
ひとつにしたら問題なく起動してきたことがあったけれど、
今回は、まだ、はて?の状態なのですが。
ま、あせることもないので、あれこれ考えなが、です。
なかたにちえ
--
Chie Nakatani <jeannechie@xxxxxxxxxxxxxxxxxxxxx>
- References
-
- [plamo:32784] Re: Plamo-7.1b1 テスター募集, KATOH Yasufumi
- [plamo:32786] Re: Plamo-7.1b1 テスター募集, Chie Nakatani
[検索ページ]
[メール一覧]
Plamo ML 公開システム